Hilfreiches

Überarbeiten der Foils

Jeder kommt mal an den Punkt, wo er dringend seine Foils neu lackieren muss. Hier gibt es eine Menge Fragen.
Ganz hilfreich sind die Finishing-Tipps von Simon Maguire (nicht nur für Exocet-Owner). Vielen Dank Simon.

Top 10 Foils Finishing Tips (Simon Maguire)

Ergänzung zum Ausbessern der Sikafuge auch von Simon bzw. seiner Frau:

"The top of the hinge where the Sika is. We paint over the whole lot. And then we remove the Sika with corse sandpaper. Then we 600 grit the foil and then we re Sika them. Leave for three or four days. Then sand and polish."

"We use Sikaflex 291i, as long as the old sika is well sanded with 80/120 grit sandpaper you can use a new layer over the old sika. Stop sanding if you see the Kevlar start to show through, be very careful not to sand this, particular at the tips of the foil."

What do you do about the flap join at the underside? Do you mask the gap for painting? --> Simon: "There are 2 options: Spray foils assembled and wedge the flap down to close the gap and reduce the chance of paint filling the gap under the foil. Or spray the underside of the foil at an angle from the front of the foil to avoid it going in the gap.
Be careful spraying dura pox or any paints, its nasty stuff if you don’t follow the recommend H&S."

 

International Moth Speed Guide

Rob Greenhalg beschreibt das Mothsegeln und gibt Empfehlungen zum Moth-Tuning und wie man auf unterschiedlichen Kursen schnell untzerwegs ist. Fragen auf die man immer schon mal die Antwort eines Profiseglers hören wollte. Da ist sicher das ein oder andere für jeden von uns dabei.

Moth Speed Guid